How to show the Netapp Aggregate status from the command line. This Netapp HowTo is useful for the following- Show Aggregate Status
- How to display Aggregate Status
- Show Aggr Status
How to show the Netapp Aggregate status from the command line. This Netapp HowTo is useful for the following
Войти в режим cli и ввести.
Одним из важных аспектов управления сетевыми устройствами является понимание версии BIOS, поскольку она может влиять на совместимость, безопасность и функциональность оборудования. Устройства Juniper, широко используемые в корпоративных и провайдерских сетях, требуют от инженеров не только глубоких знаний в области сетевых протоколов, но и навыков работы с их системным программным обеспечением. В данной статье мы рассмотрим пошаговый процесс получения информации о версии BIOS на устройствах Junipe.
Войти в режим cli и ввести.You can install the Junos OS using the Trivial File Transfer Protocol (TFTP) method. The device is shipped with the Junos OS loaded on the primary boot device. During the Junos OS installation from the loader, the device retrieves the Junos OS package from a TFTP server. The internal media is then formatted, and the Junos OS image is installed.
From the loader installation, you can:
Note: Installation from a TFTP server can only be performed using the first onboard Ethernet interface. Installation from the loader-over-TFTP method does not work reliably over slow speeds or large latency networks. |
Before you begin, verify that:
To install the Junos OS image on the internal media of the device:
The following messages appear:
Clearing DRAM........ done BIST check passed. Net: pic init done (err = 0)octeth0 POST Passed
After this message appears, you see the following prompt:
Press SPACE to abort autoboot in 3 secondsThe => U-boot prompt appears.
Table 1: Environment Variables Settings
1
| |
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 | |